🔧 ESP32 Firmware Flash Tool
Web-based flashing via Chrome/Edge browser
Connect your ESP32 board via USB and flash the GPS tracker firmware directly from your browser. No additional software installation required!
Connect your ESP32 board via USB and flash the GPS tracker firmware directly from your browser. No additional software installation required!
⚠️ Requirements:
- Chrome 89+ or Edge 89+ browser (Safari and Firefox not supported)
- USB cable connection to ESP32
- ESP32 in download mode (usually automatic)
📋 Flashing Instructions
1
Connect via USB
Connect your BerryBase NodeMCU-ESP32 board to your computer using a USB cable.
Connect your BerryBase NodeMCU-ESP32 board to your computer using a USB cable.
2
Click "Install GPS Tracker"
Click the install button below and select the USB port in the popup.
Click the install button below and select the USB port in the popup.
3
Configure device
After flashing, the device will create a WiFi hotspot for initial configuration.
After flashing, the device will create a WiFi hotspot for initial configuration.
🔌 Supported Hardware
🌟 BerryBase NodeMCU-ESP32
ESP32
Recommended board - Well-tested ESP32 development board with excellent compatibility.
Perfect for beginners and reliable GPS tracking projects.
SDMMC SD Card
WiFi + Bluetooth
30 GPIO Pins
Well Documented
Latest firmware build
🔗 Need help?
Check the Firmware Flashing Guide for detailed instructions and troubleshooting.
Check the Firmware Flashing Guide for detailed instructions and troubleshooting.
🛠️ Alternative flashing methods:
If web flashing doesn't work, you can download the firmware binaries from the GitHub releases and flash them using ESPHome or esptool.py.
If web flashing doesn't work, you can download the firmware binaries from the GitHub releases and flash them using ESPHome or esptool.py.